Linear Analysis Using S-Parameters, Group Delay and Noise Figure as Measurements

Description

This simulation setup performs a yield analysis using the amplifier's small signal S-parameters, group delay and noise figure as measurements. Specifically S11, S22 and S21 are the S-parameters used. When the simulation is complete the estimated yield is given, and the data is ready to be analyzed using the appropriate data displays.

Needed to Use Schematic

An amplifier schematic using linear or nonlinear models must be inserted into the schematic. A sample schematic, Sample_Stat_PA, is initially present, inserted into the simulation schematic.

Main Schematic Settings

Follow all the numbered steps in the upper left-hand box on this statistical analysis schematic.
Using the same parameters you initially used with the Amplifier DesignGuide, set the frequency sweep range.

Data Display Outputs

There are 2 data displays associated with this schematic:

Schematic Name

YAS_SParams_GrpDly_NF
where YAS is Yield Analysis Schematic.

Data Display Names

YSH_SParams_GrpDly_NF_One.dds
YSH_SParams_GrpDly_NF_Two.dds

 

Privacy Statement  | Terms of Use  | Legal | Contact Us  | © Agilent 2000-2008 

Contents
Additional Resources